English German (de_DE)
Filtering Bridges
Abstract Zusammenfassung
Often it is useful to divide one physical network (like an Ethernet) into two separate segments without having to create subnets, and use a router to link them together. The device that connects the two networks in this way is called a bridge. A FreeBSD system with two network interfaces is enough in order to act as a bridge.
A bridge works by scanning the addresses of MAC level (Ethernet addresses) of the devices connected to each of its network interfaces and then forwarding the traffic between the two networks only if the source and the destination are on different segments. Under many points of view a bridge is similar to an Ethernet switch with only two ports.
'''
Why use a filtering bridge?
More and more frequently, thanks to the lowering costs of broad band Internet connections (xDSL) and also because of the reduction of available IPv4 addresses, many companies are connected to the Internet 24 hours on 24 and with few (sometimes not even a power of 2) IP addresses. In these situations it is often desirable to have a firewall that filters incoming and outgoing traffic from and towards Internet, but a packet filtering solution based on router may not be applicable, either due to subnetting issues, the router is owned by the connectivity supplier (ISP), or because it does not support such functionalities. In these scenarios the use of a filtering bridge is highly advised.
A bridge-based firewall can be configured and inserted between the xDSL router and your Ethernet hub/switch without any IP numbering issues.
How to Install
Adding bridge functionalities to a FreeBSD system is not difficult. Since 4.5 release it is possible to load such functionalities as modules instead of having to rebuild the kernel, simplifying the procedure a great deal. In the following subsections I will explain both installation ways.
_Do not_ follow both instructions: a procedure _excludes_ the other one. Select the best choice according to your needs and abilities.
Before going on, be sure to have at least two Ethernet cards that support the promiscuous mode for both reception and transmission, since they must be able to send Ethernet packets with any address, not just their own. Moreover, to have a good throughput, the cards should be PCI bus mastering cards. The best choices are still the Intel EtherExpress(TM) Pro, followed by the 3Com(R) 3c9xx series. To simplify the firewall configuration it may be useful to have two cards of different manufacturers (using different drivers) in order to distinguish clearly which interface is connected to the router and which to the inner network.
Kernel Configuration
So you have decided to use the older but well tested installation method. To begin, you have to add the following rows to your kernel configuration file:
options BRIDGE
options IPFIREWALL
options IPFIREWALL_VERBOSE
The first line is to compile the bridge support, the second one is the firewall and the third one is the logging functions of the firewall.
Now it is necessary to build and install the new kernel. You may find detailed instructions in the link:{handbook}#kernelconfig-building[Building and Installing a Custom Kernel] section of the FreeBSD Handbook.
Modules Loading
If you have chosen to use the new and simpler installation method, the only thing to do now is add the following row to [.filename]#/boot/loader.conf#:
bridge_load="YES"